landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

DESCRIPTION AND OPERATION|Description|Page 1526 > < DESCRIPTION AND OPERATION|Description|Page 1524
Page 1290
background image

BODY CONTROL UNIT

DESCRIPTION AND OPERATION

86-3-3

BCU outputs
The BCU processes the input signals it receives and uses the information to determine the control outputs that need 
to be established for any given set of conditions. The BCU provides controlled outputs for the following systems:

l

Interior courtesy lamps.

l

Fuel flap release actuator.

l

Anti-theft status LED.

l

Engine Control Module.

l

Door lock actuators.

l

Direction indicators and hazard warning lamps.

l

Headlamps.

l

Alarm sounder.

l

Vehicle horns.

l

Battery backed sounder.

l

Starter relay.

l

Passive re-mobilisation exciter coil.

Simultaneous switching of outputs in different units is limited by the bus transfer time, but the skew is no longer than 
100 ms for either the BCU or the IDM. When the processor is reset, all outputs are switched off until the inputs have 
been read for the first time to check current condition.

BCU to harness connectors

Connector C0661
Connector C0662
Connector C0663

Connector C0660
Connector C0664

The pinout details for the BCU connectors are defined below:

DESCRIPTION AND OPERATION|Description|Page 1526 > < DESCRIPTION AND OPERATION|Description|Page 1524