Discovery II
EXTERIOR FITTINGS
REPAIRS
76-2-9
Bonnet
$% 76.16.01.99
Remove
1. Support bonnet in open position.
2. Fit protection covers to wings and mark hinge
outline on bonnet if bonnet is to be refitted.
3. Disconnect windscreen washer tube at elbow
joint.
4. With assistance, remove bolts securing hinges
to bonnet and remove bonnet.
Refit
1. With assistance, position bonnet to hinges. Fit
and lightly tighten bolts.
2. Connect windscreen washer tube.
3. Close bonnet. Check that bonnet is aligned to
both front wings and that gaps are equal. If
necessary, adjust bonnet alignment and/or
gaps.
4. Finally tighten hinge bolts to 25 Nm (18 lbf.ft).
Cable - bonnet release - up to 03MY
$% 76.16.29
Remove
1. Remove front grille.
2. Release LH headlamp from adjuster pin
sockets.
3. Disconnect 2 multiplugs from headlamp and
remove headlamp.
4. Drill out 4 rivets securing bonnet lock shield to
bonnet platform and remove shield.
5. Disconnect bonnet release cable inner and
outer from lock.