Discovery II
SUNROOF
REPAIRS 76-6-19
Drive cable assembly
$% 76.84.09
This procedure is applicable to the drive cable
assembly of both sunroofs.
Remove
1. Remove sunroof:
l
For front drive cable assembly:
l
For rear drive cable assembly:
2. Position sunroof assembly on suitable work
bench.
3. Remove 4 Torx screws securing glass to
sunroof frame.
4. Remove sunroof glass.
5. Release both glass carriers from cables and
remove.
6. Remove 10 Torx screws securing frame to
drive cable assembly.
7. Remove drive cable assembly from frame.
Refit
1. Fit drive cable assembly to frame.
2. Fit Torx screws securing frame to drive cable
assembly and tighten to 2.5 Nm (1.8 lbf.ft).
3. Fit glass carriers to cables.
4. Fit glass to sunroof frame and secure with Torx
screws. Do not fully tighten screws at this
stage.
5. Fit sunroof.
l
For front drive cable assembly:
l
For rear drive cable assembly:
6. Remove timing pegs supplied with drive cables.
7. Adjust position of sunroof glass in relation to
sunroof panel until a 6.5 mm (0.25 in) gap is
produced between the front edge of the glass
and the sunroof frame.
8. Tighten sunroof glass retaining screws to 3 Nm
(2.2 lbf.ft).