Discovery II
SUNROOF
76-6-16 REPAIRS
Sunroof - rear
$% 76.84.02
Remove
1. Remove sunroof motor.
2. Models with rear A/C:
a Drill out 4 rivets securing rear centre duct to
roof.
b Release and remove rear centre duct.
c Drill out 2 rivets securing each upper side
duct to roof.
d Remove upper side ducts.
3. Disconnect drain tubes from sunroof tray.
4. Remove 14 screws securing sunroof tray to
sunroof frame.
5. Carefully remove sunroof tray.
6. With assistance, remove sunroof frame and
glass assembly.
Refit
1. With assistance, fit sunroof frame and glass
assembly.
2. Position sunroof tray to roof and locate on front
edge and on rear location pin, arrowed in
illustration.
3. Fit Torx screws securing sunroof tray to frame
and tighten to 2 Nm (1.5 lbf.ft) in the order
shown.
4. Fit sunroof motor. Do not fit headlining at this
5. Models with rear A/C:
a Fit upper side ducts and secure with rivets.
b Fit rear centre duct and secure with rivets.
6. Connect drain tubes to sunroof.
7. Check operation of sunroof.
8. Pour water over sunroof and check for water
leaks.
9. Fit headlining.