Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)22 · Brakes
22 · Brakes

Switch - brake light

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
Repairs › Switch - brake light
BrakesSwitch - brake light · page 1 of 2

SWITCH - BRAKE LIGHT

Service repair no - 70.35.42

Remove

Switch - brake light – Service repair no - 70.35.42
  1. Release 2 Lucar connectors from switch.
  2. Release bayonet fixing and remove switch.

Refit

  1. Fit switch to pedal box.
  2. Connect Lucar connectors.
  3. Adjust switch See Adjustments.

BRAKE PADS - FRONT SET

Service repair no - 70.40.02

Remove

  1. Raise front of vehicle.

WARNING: Support on safety stands.

  1. Remove road wheel(s).

WARNING: Brake pads must be renewed in axle sets only. Braking efficiency may otherwise be impaired.

Brake pads - front set – Remove road wheel(s).
  1. Remove lower guide pin bolt from caliper and pivot caliper housing upwards.

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.