landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Oil seal - differential housing|Page 512 > < Differential assembly - V8|Page 510
Page 424
background image

FRONT DIFFERENTIAL

REPAIRS

54-9

19. Check alignment and connect column to PAS 

rack. Fit and tighten new clamp bolt to 24 Nm 
(18 lbf.ft).

20. Fit differential oil seal.

 

 + 

 FRONT DIFFERENTIAL, REPAIRS, 

Oil seal - differential housing.

21. Fit RH drive shaft seal.

 

 + 

 DRIVESHAFTS, REPAIRS, Seal - 

drive shaft - front - RH.

22. Fit front propeller shaft.

 

 + 

 DRIVESHAFTS, REPAIRS, Propeller 

shaft - front.

23. Fill differential to correct level with oil.

 

 + 

 FRONT DIFFERENTIAL, 

ADJUSTMENTS, Front differential - drain 
and refill.

24. Fit viscous fan.

 

 + 

 COOLING SYSTEM - V8, REPAIRS, 

Coupling unit - viscous fan.

25. Fit air intake plenum.

 

 + 

 HEATING AND VENTILATION, 

REPAIRS, Filter - fresh air intake.

26. Connect battery earth lead.
27. Bleed PAS system.

 

 + 

 STEERING, ADJUSTMENTS, Power 

assisted steering (PAS) system - bleed.

28. Check and if necessary adjust wheel 

alignment. 
 

 + 

 STEERING, ADJUSTMENTS, Front 

wheel alignment - check & adjust.

Oil seal - differential housing 

$% 54.10.18

Remove

1. Disconnect battery earth lead.
2. Raise front of vehicle.

WARNING: Do not work on or under a 
vehicle supported only by a jack. Always 
support the vehicle on safety stands.

3. Remove road wheel.
4. Remove brake disc.

 

 + 

 BRAKES, REPAIRS, Brake disc - 

front.

5. Release ABS sensor lead from clip.

6. Release sensor lead from damper, remove 

Allen screw and release ABS sensor from hub.

M54 0175

M70 1131

Oil seal - differential housing|Page 512 > < Differential assembly - V8|Page 510