landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Differential assembly - V8|Page 509 > < Differential assembly - Td6|Page 507
Page 421
background image

FRONT DIFFERENTIAL

54-6

REPAIRS

21. Connect vacuum hoses to 'T' piece and fit 

hoses to clips.

22. Ensure pinion timing marks are aligned and 

connect column to PAS rack. Fit and tighten 
clamp screw to 24 Nm (18 lbf.ft).

23. Fit differential oil seal.

 

 + 

 FRONT DIFFERENTIAL, REPAIRS, 

Oil seal - differential housing.

24. Fit RH drive shaft seal.

 

 + 

 DRIVESHAFTS, REPAIRS, Seal - 

drive shaft - front - RH.

25. Fit front propeller shaft.

 

 + 

 DRIVESHAFTS, REPAIRS, Propeller 

shaft - front.

26. Fill differential to correct level with oil.

 

 + 

 FRONT DIFFERENTIAL, 

ADJUSTMENTS, Front differential - drain 
and refill.

27. Fit undertray.

 

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Undertray - front.

28. Fit air intake plenum.

 

 + 

 HEATING AND VENTILATION, 

REPAIRS, Filter - fresh air intake.

29. Fit cooling fan.

 

 + 

 COOLING SYSTEM - Td6, REPAIR, 

Coupling unit - viscous fan.

30. Connect battery earth lead.
31. Bleed PAS system.

 

 + 

 STEERING, ADJUSTMENTS, Power 

assisted steering (PAS) system - bleed.

32. Check and if necessary adjust wheel 

alignment. 
 

 + 

 STEERING, ADJUSTMENTS, Front 

wheel alignment - check & adjust.

Differential assembly - V8 

$% 54.10.01

Remove

1. Position vehicle on lift.
2. Disconnect battery earth lead.
3. Remove air intake plenum.

 

 + 

 HEATING AND VENTILATION, 

REPAIRS, Filter - fresh air intake.

4. Remove viscous fan.

 

 + 

 COOLING SYSTEM - V8, REPAIRS, 

Coupling unit - viscous fan.

5. Place container beneath PAS pump, remove 

pipe union and allow fluid to drain. Plug 
connections.

6. Discard 'O' ring from PAS pipe.

7. Remove 2 nuts securing engine brackets to 

mountings.

8. Connect chain to lifting bracket and take weight 

of engine.

Differential assembly - V8|Page 509 > < Differential assembly - Td6|Page 507