LR3/Disco 3
Vehicles with differential locking motor: Connect the electrical connectors.
Secure the wiring harness clips.
3 .
Attach the driveshaft to the rear axle drive flange.
Clean the component mating faces.
Tighten the new Torx bolts to 63 Nm (46 lb.ft).
4 .
Install the muffler assembly. For additional information, refer to
Muffler (30.10.11)
(Section 309-00)
5 .
Clean the components.
6 .
Using the special tools, install a new halfshaft oil seal.
The halfshaft oil seal protector must be left in place, until the halfshaft is fully installed.
7 .
With assistance, install the halfshaft.
Install the snap ring.
Open the halfshaft oil seal protector.
Make sure the snap ring is fully engaged and retains the halfshaft.
8 .
NOTE:
The oil seal protector is designed to break into two pieces.
Remove and discard the halfshaft oil seal protector.
9 .
Using the special tools, install the halfshaft in the wheel hub.