Range Rover P38
64
REAR SUSPENSION
NEW RANGE ROVER
4
REPAIR
DRIVE SHAFT AND HUB ASSEMBLY
Service repair no - 64.15.01
Remove
NOTE: This procedure gives removal
instructions for the drive shaft and oil seal,
plus the hub, bearing and drive flange
assembly.
NOTE: If the hub and drive shaft are to be
removed as an assembly, it is not
necessary to slacken the drive shaft nut.
1. Remove centre cap from front wheel, release
stake from drive shaft nut. Slacken nut.
2. Remove brake disc shield.
See BRAKES,
Repair.
3. Remove 2 bolts, remove backplate strap from
hub.
4. Release ABS sensor from hub, remove sensor
seal and bush.
5. Remove 6 bolts, remove hub and half shaft
assembly from axle.
6. Secure hub and half shaft assembly in vice.
Remove drive shaft nut and remove hub from
shaft.
7. Remove seal from axle casing.