Range Rover P38
ELECTRONIC AIR SUSPENSION
5
REPAIR
Refit
8. Clean splines and seal mating faces.
9. Lubricate lip of oil seal, fit to axle case.
10. Apply a 3mm band of Loctite (grade 648) to hub
flange spline.
11. Fit hub to half shaft and fit nut, finger tight.
12. Remove shaft and hub assembly from vice.
13. Fit hub to axle case, fit bolts. Tighten to
65 Nm.
(48 lbf.ft)
14. Clean ABS sensor, bush and mating face.
15. Fit a new ABS sensor bush. Fit sensor to
location in hub.
16. Fit brake disc shield.
See BRAKES, Repair.
17. Remove safety stands. Lower vehicle.
18. Tighten drive shaft nut to
260 Nm. (192 lbf.ft)
19. Stake the nut.
20. Fit road wheel centre.
PANHARD ROD AND BUSHES
Service repair no - 64.35.50 - Panhard rod
Service repair no - 64.35.51 - Bushes
Remove
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Remove nut and bolt securing panhard rod to
chassis.
3. Remove locking plate screw, locking plate and
bolt securing panhard rod to axle.
4. Remove panhard rod.
5. Press out bushes from panhard rod. Ensure that
pressure is applied to the outer edge of bush,
not rubber inner.