Range Rover P38
ELECTRONIC AIR SUSPENSION
7
REPAIR
4. Remove bolt securing shock absorber to
chassis.
5. Remove shock absorber lower fixing.
6. Remove shock absorber.
Refit
7. Fit shock absorber, ensure lower mounting
rubbers are fitted as shown.
8. Tighten top mounting bolt to
125 Nm. (92 lbf.ft)
9. Tighten lower mounting nut to
45 Nm. (33 lbf.ft)
10. Fit road wheel. Tighten to
108 Nm. (80 lbf.ft)
11. Remove jack.
12. Remove safety stands. Lower vehicle.
TRAILING ARM AND BUSHES
Service repair no - 64.35.46 - Trailing arm
Service repair no - 64.35.48 - Bushes
Remove
1. Raise vehicle on four post lift.
2. Depressurise air suspension.
See FRONT
SUSPENSION, Repair.
3. Raise rear of vehicle to give enough clearance
for shock absorber to be disconnected.
4. Remove nut securing shock absorber to axle.
Release shock absorber, collect mounting
rubbers.
5. Release height sensor link from trailing arm.
CAUTION: Ensure that rubber mounting
does not become damaged.
6. Remove 2 nuts and bolts securing trailing arm to
axle.
7. Remove nut and bolt securing trailing arm to
chassis.
8. Remove trailing arm.