Range Rover P38
75
SUPPLEMENTARY RESTRAINT SYSTEM
NEW RANGE ROVER
8
REPAIR
47. Route SRS crash sensor harnesses through
bulkhead into wheel arches, locate harness
grommets.
48. Secure harness clips beneath wheel arches.
49. Route harnesses through valances into engine
bay. Locate harness grommets.
50. Raise battery tray and air cleaner for access.
Route crash sensor harnesses. Secure harness
clips.
51. Connect multiplugs to crash sensors.
52. Secure battery tray and air cleaner with bolts.
53. Connect SRS harness multiplug to main
harness. Secure multiplug to bracket.
54. Fit air cleaner baffle beneath LH wheel arch.
Secure with trim studs.
55. Fit wheel arch liners.
See CHASSIS AND
BODY, Repair.
56. Position driver’s side lower closing panel.
Connect footwell lamp multiplug.
57. Align closing panel. Secure with scrivet
fasteners.
58. Position ’A’ post lower trim panels. Engage
sprag clips. Secure with screws.
59. Re-fit door aperture seals.
60. LHD automatic vehicles only: Position foot
rest. Secure with bolts.
61. Position heater controls. Connect multiplugs.
Secure to fascia with screws.
62. Position fascia switch pack. Connect multiplugs.
Secure to fascia with screws.
63. Fit instrument pack binnacle.
See
INSTRUMENTS, Repair.
64. Fit radio.
See ELECTRICAL, Repair.
65. Fit passenger air bag module.
See this section.
66. Fit centre console.
See CHASSIS AND BODY,
Repair.
67. Fit battery.
See ELECTRICAL, Repair.
68. Remove safety stands. Lower vehicle.
SRS CRASH SENSOR
Service repair no - 76.73.70
Remove
WARNING: Always disconnect negative
lead from battery first. Disconnection of
positive lead with negative lead connected
risks short circuit and severe sparking through
accidental grounding of spanner. Personal injury
could result.
1. Disconnect both battery terminals.
2. Disconnect sensor multiplug.
3. Remove 2 bolts securing sensor to valance.
Remove sensor.
Refit
4. Reverse removal procedure.