Range Rover P38
SUPPLEMENTARY RESTRAINT SYSTEM
7
REPAIR
30. Disconnect driver’s air bag module connector.
Release connector and harness from clips.
31. Release 13 clips securing SRS harness to fascia
frame.
NOTE: Due to restricted access, two outer
clips ’A’ securing harness above heater
unit may have to be cut. Ensure that
location holes are clear. Collect loose ends of
clips.
32. Release 3 clips securing fascia harness trunking
to passenger side fascia frame.
33. Remove nut securing lower end of each blower
assembly to fascia frame.
34. Route crash sensor ends of harness into
passenger air bag module space.
35. Feed SRS DCU connector into passenger air
bag module space.
36. Remove harness.
Refit
37. Position harness in passenger air bag module
space. Feed SRS DCU connector between
heater and fascia frame.
38. Route harness along transmission tunnel.
Secure harness clips.
39. Connect multiplug to DCU.
40. Fit sound deadener pad to transmission tunnel.
41. Route crash sensor ends of harness correctly
around fascia frame and behind blower
assemblies.
42. Secure harness clips to fascia frame.
43. Position fascia harness trunking. Secure with
clips.
44. Secure blower assemblies to fascia frame with
nuts.
45. Connect drivers air bag module, secure
multiplug and harness to trunking.
46. Connect SRS multiplug to instrument pack.