Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Battery recharging [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Battery recharging [lf]
ElectricalBattery recharging [lf]

CAUTION: Operating electrical loads while the back-up current is being measured can damage the tester.

NOTE: For vehicles with the immobilizer system, the system periodically shifts synchronization of the security light flashing. Therefore, 45 mA (0.1s) current is supplied when the security light is illuminated, and 25 mA (2s) current is supplied when the security light is not illuminated. In addition, the measuring instrument, which shows the average value, indicates around 30 mA.

Battery back-up current

Vehicles with immobilizer system: 25-45 Ma

Vehicles without immobilizer system: 30 mA or less

  1. Inspect and repair wiring harnesses and connectors of the fuse where the current has decreased.

BATTERY RECHARGING [LF]

WARNING: Keep all flames away from the battery, otherwise evaporated gas from the battery fluid may catch fire, and cause serious injury.

Remove the battery filler caps when recharging to prevent battery deformation or damage.

CAUTION: Do not quick charge for more than 30 min. It will damage the battery.

  1. Remove the battery and then place it in a pan of water.
  2. Connect a battery charger to the battery and adjust the charging current as follows.

Battery slow charge current

46B24L (36): 3.5-4.5 A

Battery quick charge current [30 min.]

46B24L (36): 25 A

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.