Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Generator inner parts

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Generator inner parts
ElectricalGenerator inner parts · page 1 of 2
ELECTRICAL – Charging System – figure

PCM, generator,

4

No

or both are not normal.

value 100%?

Monitor the ALTF PID using the M-MDS or equivalent, or calculate the

Yes

PCM input error.

duty value of the PCM terminal 2AI using an oscilloscope. Is the duty

ELECTRICAL – Charging System – figure

5

PCM, generator,

No

or both are not normal.

value 0%?

(1) Headlights, blower motor, rear window defroster, and brake light.

(2) If the generator field coil duty value does not change when electrical loads (such as headlights,

blower motor, rear window defroster, brake light) are on or off, inspection with discharged battery is needed.

GENERATOR INNER PARTS

Rotor

  1. Measure the resistance between the slip rings using a tester.
    • If not within the specification, replace the rotor.

Generator rotor resistance (between slip rings) [20°C {68°F}]

2.0-2.3 ohm

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.