Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Current

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Current
ElectricalCurrent
ELECTRICAL – Charging System – figure
Fig. 6: Identifying Ignition Switch Connector Terminals
Courtesy of MAZDA MOTORS CORP.

Current

NOTE: Since the charging current decreases rapidly after starting the engine, carry out the following procedure quickly, and read the maximum current value.

  1. Verify that the battery is fully charged.
  2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION [LF] .)
  3. Disconnect the negative battery cable.
  4. Connect a tester, which can read 120 A or more , between generator terminal B and the wiring harness.
  5. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  6. Turn off all electrical loads.
  7. Start the engine.
  8. Increase engine speed to 2,500 rpm.

NOTE: When the electrical load of the vehicle is low, the specified current

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.