Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Rectifier (Using an analog circuit tester)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Rectifier (Using an analog circuit tester)
ElectricalRectifier (Using an analog circuit tester)
ELECTRICAL – Charging System – figure
Fig. 14: Measuring Force Of Brush Spring Using Spring Pressure Gauge
Courtesy of MAZDA MOTORS CORP.
  1. Read the spring pressure gauge at the brush tip projection of 2 mm {0.079 in}.
    • Replace the brush spring if necessary.

Generator brush spring force

Standard: 4.1-5.3 N {0.42-0.54 kgf, 0.92-1.19 lbf}

Minimum: 1.7 N {0.17 kgf, 0.38 lbf}

Rectifier (Using an analog circuit tester)

  1. Inspect for continuity of the diodes using an analog circuit tester.
    • If not as specified, replace the rectifier.

Specification

RECTIFIER SPECIFICATION USING AN ANALOG CIRCUIT TESTER

Negative

Positive

Continuity

E

P1, P2, P3, P4, P5, P6

Yes

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.