Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Standard specification

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Standard specification
ElectricalStandard specification

BATTERY INSPECTION TABLE

Table incomplete in source. The printed source cuts this table off at the right page edge, so some text in the last column is missing.

StepInspectionAction
1Measure the battery positive voltage.12.4 V or moreGo to Step 3.
Less than
12.4 V
Go to the next step.
2Quick charge for 30 min. and recheck voltage.12.4 V or moreGo to the next step.
Less than
12.4 V
Replace the battery.
3Using the battery load tester, apply load current (see Battery load test current) and record battery voltage after 15 s. Is voltage more than specification?YesNormal
NoReplace the battery.

Battery load test current

46B24L (36): 135 A

STANDARD SPECIFICATION

BATTERY STANDARD SPECIFICATION

Battery temp. (°C {°F})Minimum voltage (V)
4 {39}9.3
10 (50}9.4
16 (61}9.5
21 {70}9.6

BACK-UP CURRENT

  1. Verify that the ignition switch is off (key has been removed) and that all doors are closed.
  2. Remove the battery cover.
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  4. Connect the tester between the negative battery terminal and negative battery cable, leave the battery undisturbed for 30 min. , and then measure the back-up current.
    • If not within the specification, measure the back-up current while removing the fuses one by one from the inside of the main fuse block and the inside of the fuse block.

NOTE: If the battery is not left undisturbed for 30 min., the tester will indicate a high value (approx. 300 mA).

If the key or any electrical accessory is operated within approx. 30 min. after the tester is connected, the battery must be left undisturbed for approx. 30 min. from that point.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.