Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Pcm and generator shearing inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Pcm and generator shearing inspection
ElectricalPcm and generator shearing inspection

will not be verified although the generator is normal. In this case, increase the electrical load (by turning on the headlight and leave it for a while, then discharge the battery or by similar methods) and recheck.

  • When the generator itself or the ambient temperature are too high, the specified current cannot be verified. In this case, cool down the generator and recheck.
  1. Turn the following electrical loads on and verify that the current reading increases more than the minimum value indicated below.
    • If it is not as specified, go to the PCM AND GENERATOR SHEARING INSPECTION.
    • Headlights (high-beam)
    • Blower motor (HI)
    • Rear window defroster
    • Brake light

Generator generated current minimum value

70% of the nominal output current (nominal output current: 100 A)

[ambient temp. 20°C {68°F}, voltage 13.0-15.0 V, both engine and generator are hot]

PCM AND GENERATOR SHEARING INSPECTION

  1. Connect the M-MDS or equivalent to the DLC-2.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.