Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)11 · Electrical
11 · Electrical

Generator warning light

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Charging System › Generator warning light
ElectricalGenerator warning light

CAUTION: Do not apply direct battery positive voltage to the generator terminal D, otherwise it could cause damage to the internal parts (power transistor) of the generator.

GENERATOR WARNING LIGHT

  1. Verify that the battery is fully charged.
  2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION [LF] .)
  3. With the ignition switch turned to the ON position, verify that the generator warning light illuminates.
    • If it does not illuminate, inspect the generator warning light and the wiring harness.
    • If the generator warning light and the wiring harness are normal, inspect the PCM.
  4. Verify that the generator warning light goes out after the engine is started.
    • If it does not go out, inspect if any one of the following DTCs in the on-board diagnostic system are displayed: P0112, P0113, P2502, P2503, P2504. (See DTC TABLE [LF] .)

GENERATOR

Voltage

  1. Verify that the battery is fully charged.
  2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION [LF] .)
  3. Turn off all electrical loads.
  4. Start the engine.
  5. Verify that the generator rotates smoothly without any noise while the engine is running.
    • If there is any noise, find the cause and repair or replace the generator.
  6. Measure the voltage at each terminal using a tester.

Generator standard voltage [IG-ON]

Terminal B: B+

Terminal P: Approx. 1 V or less

Terminal D: Approx. 0 V

Generator standard voltage [Idle, 20°C {68°F}]

Terminal B: 13-15 V

Terminal P: Approx. 3-8 V

Terminal D: Turn the electrical loads (headlights, blower motor, rear window defroster) on and verify that the voltage reading increases.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.