Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual04 · MA - Maintenance
04 · Maintenance

MA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › MA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual
MA - MaintenanceMA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual

MA - Maintenance: CHASSIS AND BODY MAINTENANCE

CHASSIS AND BODY MAINTENANCE

Checking Rear Wheel Alignment .(I.R.S. type)

PRELIMINARY INSPECTION

2. Measure toe-in. © Tire pressure. camer ine of B00, © Whee! bearing axial play. * Shock absorber operation, © Tighten each rear axte and suspension part. © Measure vehicle height {Unladen} The vehicle must be on a favel surface both fore and aft, and laterally. © Repair or replace the damaged portion or parts, “Unladen”

Torin A= 8

Town = 20

radiator and engine oil pan all full,

Fuel tank,

— Spare tire, jack, hand tots and mats in position Pb Toe-in:

to 0 mm (-0.08 to 0 in)

=2 CAMBER —12' to 0' (Total toe-in) Camber is preset at factory and cannot be adjusted.

3. Toein can be adjusted by inside of rear arm Camber:

bushing pins.

° 18" to 0°15"

TOE.IN

1. Mark a base line across the tread.

Towin Max. 0.6 (0.378) Mex. 9.6 (0.378)

smai2a

|

Ror orm

Lenmanosr | Unie Stopper ‘SMATAA When performing toe adjustment, always set the ‘cams in the same position on the right end left rear arm bushing pins,

MA-26

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.