Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual04 · MA - Maintenance
04 · Maintenance

MA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › MA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual
MA - MaintenanceMA - Maintenance: CHASSIS AND BODY MAINTENANCE - Nissan 200SX S12 Workshop Manual

MA - Maintenance: CHASSIS AND BODY MAINTENANCE

CHASSIS AND BODY MAINTENANCE

Whee! inspection. Wheel Nut.

Check wheel rim {especially rim flange and

CAUTION:

bead seat) for rust, distortion, racks or other

Throe types of wheel nuts are used; one is © designed for use with steel wheels, two for damage. Examine wheel rim for lateral and radial runout, use with aluminum whesls, and one for use with spare wheels. Do not mix different types with dial gauge. Lateral runout (A) and radial runout {B}: ‘of wheel nuts. Be careful not to smear threaded portion of ©

0.5 mm (0.020 in} bolt and nut es well as seat of nut with oil or Mechanical average between right and grease. left radial runout:

For spare whesis only

Steel wheel ... Less than For afuminum

‘wheels onty

0.5 mm (0.020 in) Aluminum wheel 0,2 mm (0,008 in)

TW) 72-08 Nm suanzaay (8.0 10,0 kp-m, 68-72 tt4b) Tire Repair.

CAUTION: extra care not to damage When replacing tire, take tire bead, rim-flange and bead st sma4on Install tire, noting the following items: ‘Replace wheel when any of the following Install valve core and inflate to proper pressure.

a. problems occurs. Check the locating rings of the tire to be sure Bent, dented or heavily rusted

a. they show around the rim flanges on both sides. Elongated bolt holes b, Check valves for leakage after inflating tires. Excessive lateral or radial runout Besure to tighten valve caps firmly by hand. Air leaks through welds ¢, Wheel nuts will not stay tight eae

WARNING: When, while tire is being inflated, bead snaps ‘over safety hump, it might break. Thus, to avoid serious personal injury, never stand over tire when inflating it. Never inflate to a pressure greater than 40 psi (275 kPa}. If beads fail to seat at that pressure, deflate the tire, lubricate it again, and then reinflate it. If the tire is overinflated, the bead might bresk, possibly resulting in serious Personal injury.

MA-32

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.