MA - Maintenance: ENGINE MAINTENANCE - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › MA - Maintenance: ENGINE MAINTENANCE - Nissan 200SX S12 Workshop Manual
MA - Maintenance: ENGINE MAINTENANCE
ENGINE MAINTENANCE
Checking and Adjusting Idie-rpm (Cont’d)——__
START
¥
Start engine
and warm up engine until we
ec H
temperstue indent, points @ the radia
-———==——> £8 if _ ft saan copia ined
4 Stop ongioe and attach adapter herness Toharnes Dbetwwn ignition eon primary winding éennector of
rial odheems comever, Tan Inntion cal (CAIBET oni
Ts) Seen techometar eo ate
Telgnition cll tersinale Fun engine at ebout 2.000 rpm for bout 2 minutes under no-oad.
aorta + ‘ace engine two oF thras times under no: loud, then run engine for one minute at ‘dle weed, cataeT x ‘Check idle spued rpm at Engine model Cr
CA20E wr ca20E 780 = 100 i arr 700+ 100 position cAIET MIT 750+ 60 680+ 50 ox. No. /
x. Adjutt lala spend by turni Disconnsct sdapter harness connector and dusting screw. connect igeition coll harness connector to ignition coil (CA1BET only),
MA-15
Parts & tools for this job For Nissan 200SX
- PARTEngine gasket setSearch: Nissan 200SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.