Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual04 · MA - Maintenance
04 · Maintenance

MA - Maintenance: ENGINE MAINTENANCE - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › MA - Maintenance: ENGINE MAINTENANCE - Nissan 200SX S12 Workshop Manual
MA - MaintenanceMA - Maintenance: ENGINE MAINTENANCE - Nissan 200SX S12 Workshop Manual

MA - Maintenance: ENGINE MAINTENANCE

ENGINE MAINTENANCE

—Adijusting Intake and Exhaust ______ Checking and Adjusting Idle-rpm—

Valve Clearance

CAUTION: Do not attempt to screw the idle adjusting screw Adjustmant should be made while engine is warm down completely. Doing so could cause damage to but not running. tip, which in turn will tand to cause malfunctions, 1, Set No. 1 cylinder in top dead center on its compression stroke, and adjust valve clear Preparation ance ©), @, @ and ©. 2, Set No, 4 cylinder in top dead center on its

1. Make sure that the following parts are in good compression stroke, and adjust valve claar- order. ance

@, ®, D and .

© E.G.R. valve operation Air cleaner clogging © ‘Adjusting sorew lock nuts © Ignition system 18-22N-m FP): Engine cil and coolant levels

(1,8 - 2.2 kgm, 13 - 16 ft-lb)

© Valve clearance © €.F.AVE.C.CS. component parts © E.F.IYE.C.C.S. harness connectors © Vacuum hoses © Air intake system {Oil filler cap, oil level gauge, etc.)

2. Set shift lever in “Neutral” position (in “N" or “P*" position for the automatic transmission), Engage parking brake and lock both front and tear wheels with wheel chocks,

3. Tum off air conditioner and headlamps.

4. Keep front wheels straight ahead,

WARNING: a, Depress brake pedal while racing the engine to prevent forward surge of vehicle.

b. Inspection should be carried out while shift lever is in “D" position on automatic trans- mission equipped models, , After inspection and adjustment have been made, shift the lever to “"N” or "P" position on ‘automatic transmission.

Valve clearance:

0.30 mm {0.012 in}

MA-14

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.