21.INSTALL CAMSHAFT TIMING SPROCKET - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REASSEMBLY › 21.INSTALL CAMSHAFT TIMING SPROCKET - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
21.INSTALL CAMSHAFT TIMING SPROCKET

Turn
Using SST, hold the crankshaft pulley and install the supply pump shaft nut to the supply pump shaft. SST 09213-58014 (91551-80840) 09330-00021 Torque: 137 N*m (1397 kgf*cm, 101 ft.*lbf)
NOTICE: If the supply pump shaft nut is tightened with torque higher than the specified torque, the No. 1 chain sub-assembly may break.
c. Remove the crankshaft pulley set bolt and crankshaft pulley from the crankshaft.
d.

*1 Crankshaft Timing Sprocket *2 Injection Pump Drive Gear *a Mark Plate (Pink) *b Mark Plate (Yellow) *c Timing Mark
Make sure that the timing marks of the crankshaft timing sprocket and injection pump drive gear are aligned with the mark plates of the No. 1 chain sub-assembly as shown in the illustration.
e. Remove the pin from the No. 1 chain tensioner assembly.
13523
21.INSTALL CAMSHAFT TIMING SPROCKET
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.