Upper Arm - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Upper Arm - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Upper Arm
SP–31 SUSPENSION – FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) DISASSEMBLY


1.
REMOVE FRONT SUSPENSION UPPER ARM BUSH
(a) Using a hammer and chisel, raise the flange of the bushing diagonally as shown in the illustration.
G020154 (b) Using SST and a press, remove the front suspension upper arm bush LH (front side). SST 09613-26010, 09710-22021 (09710-01031), 09950-00020 SST (c) The removal procedure for the rear side is the same as that for the front side.

SST G020155E01 INSPECTION

1.
INSPECT FRONT SUSPENSION UPPER ARM
(a) Flip the ball joint stud back and forth 5 times, as SP shown in the illustration, before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn. Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf) or less (c) Check for any cracks and grease leakage on the G020170 ball joint dust cover. REASSEMBLY

1.
INSTALL FRONT SUSPENSION UPPER ARM BUSH
SST (a) Using SST and a press, install a new upper arm bush (front side). SST 09710-26010 (09710-05061) (b) The installation procedure for the rear side is the same as that for the front side.
G020156E01 INSTALLATION

1.
TEMPORARILY TIGHTEN FRONT SUSPENSION
UPPER ARM
(a) Install the front suspension upper arm, and temporarily tighten the bolt, 2 washers and nut.
G020153
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.