38261E.pdf - DISASSEMBLY OF CYLINDER - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Brakes › 38261E.pdf - DISASSEMBLY OF CYLINDER - Toyota Land Cruiser J70 Workshop Manual
38261E.pdf - DISASSEMBLY OF CYLINDER

BR-40 BRAKE SYSTEM — Front Brake (Disc Brake)
DISASSEMBLY OF CYLINDER
1.
REMOVE CYLINDER BOOT SET RING AND BOOT
Using a screwdriver, remove the cylinder boot set ring and boot.
BRO2N
2.
REMOVE PISTON FROM CYLINDER
___170 mm — 50 mm (a) Prepare the wooden plate as shown in the figure to (1.97 in.) hold the piston. (6.70 in.) ~~
16 mm (0.63 in.) 8R0212 (b)
Place the plate between the pistons and ‘insert a pad
at one side. (c) Use compressed air to remove the pistons alternate- ly from the cylinder.
WARNING: Do not place your fingers in front of the piston when using compressed air.
@n0213
3.
REMOVE PISTON SEAL
Using a screwdriver, remove the seal from the cylinder.
BRo214
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- PARTBrake padsSearch: Toyota Land Cruiser brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.