38261E.pdf - REMOVE OUTLET PLUGS - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Brakes › 38261E.pdf - REMOVE OUTLET PLUGS - Toyota Land Cruiser J70 Workshop Manual
38261E.pdf - REMOVE OUTLET PLUGS

BR-12 BRAKE SYSTEM — Master Cylinder
5.
REMOVE OUTLET PLUGS
Remove the two outlet plugs and gaskets.
REMOVE PISTON STOPPER BOLT
Using a screwdriver, push the pistons in all the way, and remove the piston stopper bolt and gasket.
REMOVE TWO PISTONS AND SPRINGS
(a) Push in the piston with a screwdriver and remove the snap ring with snap ring pliers.
03612 | (b) Remove the two pistons and springs from the master cylinder. If necessary, inject compressed air into the outlet hole to force out the piston.
BR0696
INSPECTION OF MASTER CYLINDER
NOTE: Clean the disassembled parts with compressed air.
INSPECT CYLINDER BORE FOR RUST AND SCORING
INSPECT CYLINDER FOR WEAR OR DAMAGE
If necessary, clean or replace the cylinder.
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- PARTBrake padsSearch: Toyota Land Cruiser brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.