Workshop Manuals Factory service & repair Toyota
01 Toyota Land Cruiser J7002 Toyota Land Cruiser J70 - General
Toyota Toyota Land Cruiser J70 Workshop Manual01 · Toyota Land Cruiser J70
01 · Electrical

38261E.pdf - REMOVE CROSS SHAFT - Toyota Land Cruiser J70 Workshop Manual

Make
Toyota
Model
Land Cruiser Toyota Land Cruiser J70 Workshop Manual
Section
Steering › 38261E.pdf - REMOVE CROSS SHAFT - Toyota Land Cruiser J70 Workshop Manual
Toyota Land Cruiser J7038261E.pdf - REMOVE CROSS SHAFT - Toyota Land Cruiser J70 Workshop Manual

38261E.pdf - REMOVE CROSS SHAFT

1984 LJ70 RJ70 Repair Manual 38261E: diagram

STEERING — Power Steering SR-49

REMOVE CROSS SHAFT

3.

Using a plastic hammer, tap on the cross shaft end and pull

out the shaft.

1101

REMOVE WORM GEAR VALVE BODY ASSEMBLY

(a) Remove the four cap screws from the housing. (b) Hold the power piston nut with your thumb so it can- not move, and turn the worm shaft clockwise. Then, withdraw the valve body and power piston assembly.

CAUTION: Ensure that the power piston nut does not come off the worm shaft. (c) Remove the O-ring. sA1102

REMOVE POWER PISTON NUT

(a) Mount the valve body on SST and clamp SST in vise. SST 09630-00011 (b) Pull out the power piston nut.

CAUTION: Do not lose the ball.

REMOVE LOCK NUT

(a) Using SST, hold the adjusting screw and remove the lock nut with SST. SST 09630-00011 (b) Using SST, remove the adjust screw. SST 09630-00011 (c) Remove the bearing.

ces19

REMOVE O-RING

8520)

Donated by Onur Azeri . cruisercult.com

Parts & tools for this job For Toyota Land Cruiser

As an Amazon Associate we earn from qualifying purchases.