DISCONNECT - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Steering › DISCONNECT - Toyota Land Cruiser J70 Workshop Manual
DISCONNECT

STEERING -— Steering Column Assembly with Tilt Steering SR-5
2.
DISCONNECT NO.1 AND NO.
2 INTERMEDIATE
SHAFTS (a) Place matchmarks on the joint yoke of the No. 1 and No. 2 intermediate shaft. (b) Remove the set bolt. (c) Pull out the intermediate shaft No. 1 from No. 2.
SR0996
3.
REMOVE STEERING WHEEL
(a) Remove the steering wheel pad. (b) Remove the set nut. Place matchmarks on the steering wheel and main (c) shaft. Using SST, remove the steering wheel. (d) SST 09609-20011
sR0949
4.
REMOVE AIR DUCT

5.
REMOVE COLUMN COVER
6.
REMOVE COMBINATION SWITCH
(a) Remove the four screws from the connector. Remove the clamp. (b) \ {c) Disconnect the combination switch connector. (d) Remove the combination switch.
\\
7.
REMOVE FOUR BOLTS FROM COLUMN HOLE

COVER
$R0951
8.
REMOVE STEERING COLUMN ASSEMBLY
(a) Disconnect the ignition switch connector. (b) Remove the two mount nuts. Pull out the steering column assembly. (c)

$R0362
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Toyota power steering fluid
As an Amazon Associate we earn from qualifying purchases.