Worm Shaft - Toyota Land Cruiser J70 Workshop Manual
- Make
- Toyota
- Model
- Land Cruiser Toyota Land Cruiser J70 Workshop Manual
- Section
- Steering › Worm Shaft - Toyota Land Cruiser J70 Workshop Manual
Worm Shaft

SR-48 STEERING — Power Steering COMPONENTS kg-cm (ft-lb, N-m)] : Specified torque Lock Nut : Non-reusable part @ ~ 470 (34, 46) |
@ Seal Washer 3— End Cover ~ 2 <> —ORing €—— Lock Nut Adjusting Screw — Cross Shaft @ Co @ O-Ring | O-Ring
- Valve Body _ + Power Piston Nut | 800 (36, 49) @ Teflon Ring
Worm Shaft
Gear Housing -
Bearing~———_TM} Adjusting Nut Worm Bearing O-Ring
@ Teflon Ring —2]
SS
—@ O-Ring
@ Teflon Ring
“ng
Md O-Rins Spacer-——_S> Oil Seal ——<—=> @ Teflon Ring
<P—F Snap Ring
DISASSEMBLY OF GEAR HOUSING
1.
REMOVE PITMAN ARM
(a) Mount the gear housing on SST and clamp SST in vise. SST 09630-00011 (b) Using SST, remove the pitman arm. SST 09628-62011
2.
REMOVE END COVER
(a) Remove the adjusting screw lock nut. (b) Remove the four bolts. (c) Screw in the adjusting screw until the cover is re- moved.

sA1100
Donated by Onur Azeri . cruisercult.com
Parts & tools for this job For Toyota Land Cruiser
- TOOLTie rod end toolSearch: tie rod end puller
- TOOLBall joint separatorSearch: ball joint separator
- FLUIDPower steering fluidSearch: Toyota power steering fluid
As an Amazon Associate we earn from qualifying purchases.