- Corsa C Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Inspections
- Technical Information
- OHC Petrol Engine
- DOHC Petrol Engine
- Fuel Injection Systems
- Engine Electrics
- Cooling System
- Turbo-Charging
- DOHC diesel engine
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
- Diagnostic Information and Procedures
- Technical Service Bulletins
- General
- Seals and Seal Rings
- Ribbed V-Belt
- Fuel Pump
- Engine Damping Block
- Oil Circulating
- Timing Gear Case
- Cylinder Block
- Repair Instructions
- Description and Operation
- Component Locator
- Specifications
- Guide Bearing in Crankshaft
- Crankshaft Bearing Shell
- Piston
- Crankshaft
- Repair Instructions
- Replace rear crankshaft sealing ring (Y 17 DT, without air conditioning, RHD)
- Replace front crankshaft sealing ring (Y 17 DTL, with air conditioning, LHD)
- Check crankshaft alignment (Y 17 DT, Y 17 DTL)
- Removing and installing crankshaft (Y 17 DTL)
- Front Crankshaft Seal Ring, Replace (Z 17 DTH, with AC, LHD)
- Crankshaft Sensor, Replace (Z 17 DTH, With Air Conditioning, LHD)
- Toothed Belt Drive Gear - Crankshaft Sprocket, Replace
- Rear Crankshaft Seal Ring, Replace (Z 17 DTH, Without Air Conditioning, LHD)
- Check axial play of crankshaft
- Replacing oil spray nozzles
- Crankshaft, Remove and Install
- Measuring crankshaft
- Crankshaft, Remove and Install
- Replace rear crankshaft seal ring
- Remove and install torsional vibration damper
- Toothed Belt Drive Gear - Crankshaft Sprocket, Replace
- Check crankshaft bearing clearance (with Plastigage)
- Check the bearing clearance of the crankshaft (use micrometer and internal measuring device)
- Con Rod Bearing
- Con Rod
- Flywheel
- Cylinder Head
- Vacuum Pump
- Auxiliary aggregate drive
- Toothed Belt
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories