Steering Gear, Remove and Install (Power Steering)

Make: Vauxhall
Model: Vectra B
Section: Power Steering › Repair Instructions › Steering Gear, Remove and Install

‹ Prev Hydraulic Line Seal Rings - Steering Gear, Replace Next › Technical Data (Group M) - Sealants, Lubricants and Locking Compounds

SteeringSteering Gear, Remove and Install

Steering Gear, Remove and Install

Important!

For vehicles with airbag: turn steering wheel to straight-ahead position and allow steering lock to engage.

Remove, Disconnect

Remove front axle body - see operation "Front Axle Body, Remove and Install" in group "E".

Unscrew bolts (1) from rear engine damping block and remove engine damping block. Unscrew bolts (2) from retaining brackets and remove steering gear with retaining brackets from front axle body.

Install, Connect

Install steering gear on front axle body - tightening torque 45 Nm / 33 lbf. ft. Install rear engine damping block on front axle body - tightening torque 20 Nm / 15 lbf. ft.

Install, Connect

Install front axle body - see operation "Front Axle Body, Remove and Install" in group "E".

Inspect

Check camber, and toe-in, adjust if necessary - see operation "Camber, Caster and Toe-in, Check" in group "E".

Related Literature Units
-
-
-
-

‹ Prev Hydraulic Line Seal Rings - Steering Gear, Replace Next › Technical Data (Group M) - Sealants, Lubricants and Locking Compounds

Parts & tools for this job For Vauxhall Vectra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.