Workshop Manuals Factory service & repair Volvo
01 Relays and Modules02 Sensors and Switches03 Maintenance04 Engine, Cooling and Exhaust05 Powertrain Management06 Transmission and Drivetrain07 Brakes and Traction Control08 Starting and Charging09 Power and Ground Distribution10 Steering and Suspension11 Heating and Air Conditioning12 Restraint Systems13 Accessories and Optional Equipment14 Body and Frame15 Cruise Control16 Instrument Panel, Gauges and Warning Indicators17 Lighting and Horns18 Windows and Glass19 Wiper and Washer Systems
Volvo V50 L5-2.4L VIN 39 B5244S7 (2005)01 · Relays and Modules
01 · Diagnostics

Accessory Control Module (AEM) (Body Control Module) (page 29 of 42)

Make
Volvo
Model
V50
Engine
L5-2.4L VIN 39 B5244S7
Year
2005
Section
Relays and Modules - Computers and Control Systems › Body Control Module › Service and Repair
Relays and ModulesAccessory Control Module (AEM) · page 29 of 42
Accessory Control Module (AEM) (Body Control Module) (page 29 of 42) – Volvo V50 L5-2.4L VIN 39 B5244S7 (2005)

Applies to cars from CH 40000-, with Parking Assistance Module (PAM) without a tow hitch

-

Detach the green (GN) five pin connector (1) which is taped at the Parking Assistance Module (PAM) cable's rubber grommet.

-

Plug the green connector into the Accessory Electronic Module (AEM).

-

Fit the Accessory Electronic Module (AEM) in place and tighten the two screws.

-

Position the wiring inside the panel at the rear wing.

-

Reinstall the soundproofing panel.

-

Refit the Parking Assistance Module (PAM), if the car is equipped with one. In addition, refit any detached cables.

-

Reinstall the floor support.

-

Reinstall the side panel. Tighten using the screw at the front edge. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf. ft.).

-

Reinstall the lower C-post panel.

-

Reinstall the rubber strip at the rear edge of the opening for the rear door.

-

Reinstall the panel at the front/top of the side panel. Press downwards so that the catches engage. Then tighten using the screw.

-

Reinstall the side cushion.

-

Reinstall the rubber strip in the boot lid opening.

-

Reinstall the sill trim panel for the tailgate.

-

Reinstall the cargo compartment carpet.

-

Fold the backrest and seat back into place.

-

Program the function using VCT2000.

Points 18-32 apply to S40 (04-)

-

Remove the cargo compartment carpet.

Pinch or Ctrl + scroll to zoom. Double-tap to reset.

The same page in: V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 2.4i L5-2.4L VIN 38 B5244S4 (2008), V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005), V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005).

Parts & tools for this job For 2005 Volvo V50 2.4L

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.