Workshop Manuals Factory service & repair Alfa Romeo
Alfa Romeo 145/146 Factory Service Manual (1994-1999)11 · Bodywork
11 · Body & interior

Bonnet

Make
Alfa Romeo
Model
145/146 Factory Service Manual
Year
1994–1999
Section
Mobile bodywork components › Bonnet
BodyworkBonnet

BONNET

REMOVAL/REFITTING

  • Open and suitably support the bonnet.
  1. Loosen the two screws, on each side, securing the bonnet to the hinges.
Hand loosening a screw on a bonnet hinge with a socket wrench.

6 ÷ 7 Nm
0.6 ÷ 0.8 kgm

  1. Remove the bonnet.
Car with bonnet open and supported by jack stands.

Refit the bonnet by reversing the procedure followed for removal and note the following.

  1. If a new bonnet is being used apply the specified sealant around the inner edges of the bonnet.
Bonnet with sealant applicator shown near the inner edge.
  • If necessary adjust the bonnet as described in the relative paragraph.

BONNET HINGES

REMOVAL/REFITTING

  • Remove the bonnet (see specific paragraph).
  1. Working from the wheel housing, loosen the screws securing the hinge to the body.
Close-up of hinge screws being loosened with a socket wrench.

16 ÷ 20 Nm
1.7 ÷ 2.0 kgm

Parts & tools for this job For 1994 Alfa Romeo 145/146

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.