Power unit upper reaction link r r

Operation 1008C10 · Power unit reaction elements

1.6 TS

Removing

1. Release the fuel vapour recirculation pipe from the fastening on the power assisted steering fluid reservoir.

2. Undo the bolts (2a) and (2b) and remove the power unit reaction rod (2c).

Refitting

Place the power unit reaction rod back in its housing and secure it by tightening the bolts to the recommended torque.

Fix the fuel vapour recirculation pipe with the band on the power steering fluid reservoir.

2.0 TS

Removing

1. Release the fuel vapour recirculation pipe from the fastening on the power steering fluid reservoir.

2. Disconnect the rapid attachments and remove the fuel vapour recovery pipe.

Seal the fuel vapour recovery system pipes.

1. Undo the bolts (1a) and (1b), then remove the power unit reaction rod (1c).

Refitting

Place the power unit reaction rod back in its housing and fix it tightening the bolts to the recommended torque.

Place the fuel vapour recovery pipe back in its housing and connect the rapid attachments.

Fix the fue vapour recirculation pipe with the band on the power steering fluid reservoir.

3.2 V6

Removing

1. Undo the bolts (1a) and remove the power unit reaction rod (1b).

Refitting

Place the power unit reaction rod (1a) back in its housing and fix it tightening the bolts to the recommended torque.

1.9 JTD 8V

Removing

- 1016A10 sound-proofing cover - r + r

1. Undo the bolts fixing the reaction rod to the bodyshell and to the engine.

2. Remove the reaction link.

Refitting

Fit the reaction rod and tighten the bolts fixing it to the bodyshell and the engine to torque.

- 1016A10 sound-proofing cover - r + r

1.9 JTD 16V

Removing

Proceed with removal - 7025A12 Engine front sound insulation COVER - R.R..

Proceed with removal - 7025A14 Bonnet LID - R.R..

1. Remove the engine oil filler cap.

2. Undo the fixing bolts (2a) and remove soundproofing cover (2b).

Tighten the engine oil filler cap.

1. Undo the bolts (1a) and remove the power unit reaction rod (1b).

Refitting

1. Place the power unit reaction rod (1a) back in its housing and fix it tightening the bolts (1b) to the recommended torque.

Remove the engine oil filler cap.

Place the soundproof cover back in its housing and secure using the relevant bolts.

Tighten the engine oil filler cap.

Proceed with refitting - 7025A14 Bonnet LID - R.R..

Proceed with refitting - 7025A12 Engine front sound insulation COVER - R.R..