THRUST BEARING LINKAGE - R + R WITH GEARBOX REMOVED

Operation 1820A26 · CLUTCH RELEASE MECHANICAL CONTROL

1.2 8v, 1.3 Multijet, 1.4 16v

Removing

Op. 1820A30 THRUST BEARING - R + R WITH GEARBOX REMOVED

1. Open the circlip (1a) and remove it and remove the thrust bearing control lever (1b).

1. Release the fork shaft, remove it and keep the upper and lower bushes.

Refitting

- Check the condition of the components removed.

- Replace the bushes if the fork shaft clearance is too great.

- Refit the fork control shaft.

- Place the thrust bearing control lever in position and secure to the fork shaft using the dedicated circlip.

Op. 1820A30 THRUST BEARING - R + R WITH GEARBOX REMOVED