09 · Transmission

Thrust bearing linkage - r + r

Make: Fiat
Model: 500 Factory Service Manual
Year: 2007–2024
Section: Clutch release controls › Thrust bearing linkage - r + r

‹ Prev Release cable - r + r Next › Thrust bearing linkage - r + r with gearbox removed

ClutchThrust bearing linkage - r + r

THRUST BEARING LINKAGE - R + R

Operation 1820A24 · CLUTCH RELEASE MECHANICAL CONTROL

1.2 8v, 1.3 Multijet, 1.4 16v

Removing

- Position the vehicle on a lift.

Op. 0010T40 CHANGE MANUAL GEARBOX OIL

Op. 5530B10 BATTERY - R+R

Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R

Op. 4450B12 FRONT WHEELS (TWO) - R+R

Op. 4410D22 BRACKET FIXING FRONT SUSPENSION CROSSMEMBER TO BODYSHELL (ONE), LEFT OR RIGHT - R.R.

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 7210E10 R.R. FRONT BUMPER

Op. 7210A48 R.R THIRD LOAD LINE

Op. 2110A60 MANUAL GEARBOX/ENGINE COUPLING BRACKET - R+R

Op. 1008C34 BRACKET ON GEARBOX FOR LOWER REACTION ROD - R.R.

Op. 1024B50 ENGINE FLYWHEEL COVER - R.R.

Op. 1008B30 GEARBOX SIDE SUPPORT FLEXIBLE MOUNTING(S) - REPLACE

Op. 1008A42 POWER UNIT RIGID SUPPORT - GEARBOX SIDE - R.R.

Op. 2110A10 MANUAL GEARBOX AND DIFFERENTIAL - R + R

Op. 1820A30 THRUST BEARING - R + R WITH GEARBOX REMOVED

1. Open and remove O-ring (1a) and remove thrust bearing control lever (1b).

1. Withdraw and remove the fork shaft and retrieve the upper and lower bush.

Refitting

- Check the condition of the removed components.

- Replace the bushes if there is excessive clearance on the fork shaft.

- Refit the fork control shaft.

- Position the thrust bearing control lever and attach it to the fork shaft, using the O-ring.