Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat 500 Factory Service Manual (2007-2024)22 · Fault diagnosis
22 · Diagnostics

Central locking not working

Make
Fiat
Model
500 Factory Service Manual
Year
2007–2024
Section
Doors › Central locking not working
Fault diagnosisCentral locking not working

CENTRAL LOCKING NOT WORKING

1.2 8v, 1.3 Multijet, 1.4 16v

When the central locking is activated using the mechanical key or from the inside, via the safety knob, the central locking system does not work.

N.B.: The door opening/closing command reaches the Body computer node. The latter sends the signal received to the actuators which close/open the side doors, and directly controls the closing of the boot lid.

Test results
1CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation

Connect the Examiner diagnostic equipment and check:

  • that there are no faults.
Move on to Step 2Presence of errors.Continue following the instructions for the diagnostic equipment.
2CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Keeping the Examiner diagnostic equipment connected to the Body Computer, carry out the active diagnosis for the defective door lock.Move on to Step 3The door does not close/open.Move on to Step 4
3CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Using the Examiner diagnostic equipment, check that the learning of the change of state for the door opening/closing switch is correct.Move on to Step 5The signal for the door opening/closing switch status has not been learnt correctly.Move on to Step 4
4ELECTRICAL CIRCUIT CHECKAll OKProblems encounteredOperation

Check the continuity/insulation of the electrical connection between the defective door lock and the Body Computer

Check the continuity/insulation of the electrical connection between the Body Computer, the dashboard control unit and the defective door lock

See E3040 CENTRAL LOCKING

Move on to Step 5

1. Electrical connection broken or not insulated.

2. Defective front door lock

1. Restore the electrical connection

See E3040 CENTRAL LOCKING

2. Replace the front door lock

Op. 7005N21

5CORRECT LOCK OPERATION CHECKAll OKProblems encounteredOperation
Check that the door locks are working properlyMove on to Step 6Defective front door lock

Replace the defective door lock

Op. 7005N21

6BODY COMPUTER CORRECT OPERATION CHECKAll OKProblems encounteredOperation
Check that the body computer is working properlyEnd of diagnosis.Body Computer defective

Replace body computer

Op. 5505A32 BODY COMPUTER - R.R

Parts & tools for this job For 2007 Fiat 500

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.