IGNITION COIL/S - R.R.

Operation 5510C14 · COIL, ECU, SENSORS

1.4 16v

Removing

Op. 1048A10 AIR FILTER ASSEMBLY - R.R.

1. Disconnect the electrical connection for the cam angle sensor.

2. Unscrew the bolt securing the cable loom retaining duct.

3. Disconnect the electrical connections for the ignition coils.

1. Undo bolts (1a) and remove ignition coils (1b).

Refitting

- Position the ignition coils and secure them using the retaining bolts.

- Connect the electrical connections for the ignition coils.

- Tighten the bolt securing the wiring loom retaining duct.

- Connect the electrical connection for the cam angle sensor.

Op. 1048A10 AIR FILTER ASSEMBLY - R.R.

1.4 16v TJet

Removing

Op. 1016A10 SOUND-PROOFING COVER - R.R

1. Detach the timing sensor electrical connection.

2. Undo the bolt and remove the earth lead.

- Move the ignition coils electrical connections safely clips.

3. Unscrew the nut securing the wiring harness duct.

4. Raise the clip and move the wiring harness duct.

5. Disconnect the electrical connections from the ignition coils, releasing the wiring harness duct from the stud.

6. Undo the bolts and remove the ignition coils.

Refitting

- Place the ignition coils in their housings and tighten the bolts to the recommended torque.

- Connect the electrical connections for the ignition coils.

- Tighten the the nut securing the wiring harness duct.and fasten the retaining clip.

- Connect the earth lead and tighten the bolt.

- Secure the electrical connection for the timing sensor.

Op. 1016A10 SOUND-PROOFING COVER - R.R