Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Climate control system noisy / (in passenger compartment)

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Noise / vibrations › Climate control system noisy / (in passenger compartment)
Fault diagnosisClimate control system noisy / (in passenger compartment)

CLIMATE CONTROL SYSTEM NOISY / (IN PASSENGER COMPARTMENT)

Whilst driving, a noise comes from the fan. This diagnosis can only be made after

See table S015 NOISE WHILST DRIVING

Carry out the latter first.

The climate control is working normally but there is excessive noise coming from the passenger compartment fan.

TEST RESULTS
0PRELIMINARY CHECKSALL OKPROBLEMS ENCOUNTEREDACTION

Having carried out the road test

See table S015 NOISE WHILST DRIVING

there was a noise from the front identified as coming from the passenger compartment heater fan.

Move on to Step 1
1FAN CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check the climate control fan.

In particular, check:

- that the fan and spiral is clean, if there are any foreign bodies, deposits of dust on the vanes and/or leaves remove them/blow through moving the fan from the engine support;

- that there are no breaks or cracks in the fan;

- there are no vibrations or noise at low speed (check the operation with the fan detached from the assembly but the electrical connection fitted).

"The operation for determining vibrations should be carried out with great care to avoid fragments of the fan being expelled into the surrounding area. Protective goggles must also be worn.

Move on to Step 2

1. Fan dirty.

2. Presence of breaks/cracks in the fan.

3. Electric motor noisy, fan not balanced or blades.

1. Clean the fan casing and all the ducts.

2. Replace the fan

Op. 5040C30 AIR CONDITIONING FAN - R.R.

3. Replace the fan

Op. 5040C30 AIR CONDITIONING FAN - R.R.

2AIR DUCT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check for foreign bodies and damaged components inside the air ducts.Move on to Step 3Presence of foreign bodies or damaged components inside the air ducts.Eliminate the obstructions from the dashboard ducts.
3AIR VENT CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the vents are intact and that there are no foreign bodies that could create noise.Move on to Step 4Vents obstructed.Restore the operation of the vents.
4POLLEN FILTER CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the pollen filter is not blocked and that the recirculation air intake is not blocked with foreign bodies or parts (e.g. wiring) that are not correctly fitted.Move on to Step 5

1. Filter obstructed.

2. Air intake blocked by foreign bodies.

1. Replace the filter element

Op. 5010B08 CLIMATE CONTROL OUTSIDE AIR PURIFYING (POLLEN) FILTER - R.R.

2. Eliminate the obstructions and restore correct operation.

5FAN INTAKE CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fan intake in the air intake chamber is not blocked by the presence of foreign bodies.End of diagnosisPresence of foreign bodies in the air intake chamber.Eliminate the obstructions and restore correct operation.

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.