22 · Diagnostics

Engine knock

Make: Fiat
Model: Bravo Factory Service Manual
Year: 2007–2014
Section: Noise / vibrations › Engine knock

‹ Prev Sun roof does not stop in end of travel position Next › Engine hissing

Fault diagnosisEngine knock

ENGINE KNOCK

The engine makes a cyclical noise - with the intensity varying according to the load - which is audible during brisk acceleration and when using long ratios.

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
		TEST RESULTS
	Connect the Examiner diagnostic equipment to the diagnostic socket and check that there are no faults in the engine management control unit.	Move on to Step 2	Error detected in the engine management control unit.	Continue following the instructions on the diagnostic equipment
2	AUXILIARY UNITS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Disconnect the services belt and check whether the noise disappears	Move on to Step 3	The noise disappears	Proceed as instructed in See table S010 ENGINE WHILSTLING / SERVICES BELT NOISY
3	KNOCK LOCATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Carry out a test to locate exactly the area where the knocking is coming, from using special equipment.	Move on to Step 4	1. The knocking is coming from the cylinder head 2. The knocking is coming from the crankcase.	1. Move on to Step 5 2. Move on to Step 4
4	CYLINDER BLOCK/CRANKCASE KNOCK CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Carry out a test to identify the circumstances in which the cylinder block/crankcase knock occurs.	Move on to Step 5	1. The knocking occurs with the engine cold and decreases when warm; when accelerating it is audible on overrun. 2. The knocking occurs with the engine cold and increases when accelerating in long ratios 3. The knocking is heard at all temperatures 4. The knocking is heard at all temperatures and decreases when the clutch pedal is pressed.	1. Overhaul the engine: in particular, check the condition of the pistons and, if necessary, replace them Op. 1028H10 CONNECTING ROD AND PISTON SET - R.R 2. Overhaul the engine: in particular, check the condition of the crankshaft bearings and, if necessary, replace them Op. 1024A10 CRANKSHAFT - R.R WITH ENGINE REMOVED - CHECK AND, IF NECESSARY, REPLACE MAIN JOURNALS AND CRANKPINS 3. Overhaul the engine: in particular, check the condition of the connecting rod bearings and, if necessary, replace them Op. 1024A10 CRANKSHAFT - R.R WITH ENGINE REMOVED - CHECK AND, IF NECESSARY, REPLACE MAIN JOURNALS AND CRANKPINS 4. Overhaul the engine: in particular check for crankshaft judder.
5	TAPPET KNOCKING CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	If the vehicle is not often used, it is possible that an accentuated knocking of the tappets will be heard for a few minutes during start up, which will then gradually decrease.	Move on to Step 6	Tappet knocking persists.	Check hydraulic tappets operation and replace those that do not work.
6	CYLINDER HEAD CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Overhaul the cylinder head and, in particular, check: - no cam wear; - cam axis clearance; - valves and springs.	End of diagnosis	Cam wear or incorrect camshaft clearance	Repair or replace the components concerned.

‹ Prev Sun roof does not stop in end of travel position Next › Engine hissing

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.