Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)22 · Fault diagnosis
22 · Diagnostics

Rear noise (whistling/humming)

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Noise / vibrations › Rear noise (whistling/humming)
Fault diagnosisRear noise (whistling/humming)

REAR NOISE (WHISTLING/HUMMING)

Whilst driving, especially on unmade roads, there is a whistling noise coming from the rear suspension. This diagnosis can only be made after

See table S015 NOISE WHILST DRIVING

Carry out the latter first.

If the problem is only on one side, carry out the checks and any operations on the appropriate side only.

TEST RESULTS
0PRELIMINARY CHECKSALL OKPROBLEMS ENCOUNTEREDACTION

Having carried out the road test

See table S015 NOISE WHILST DRIVING

there was a whistling noise from the back.

Continue depending on the circumstances in which the noise occurs.

End of diagnosis.

1. The noise increases when cornering.

2. The noise increases in vertical oscillation conditions.

1.Replace the wheel bearing complete with hub on the side where the noise is loudest

Op. 4450C32 ONE FRONT WHEEL HUB BEARING, LH OR RH - REPLACE

2.Move on to Step 2

1CHECK ON FASTENING OF SHOCK ABSORBER TO UPPER TURRETALL OKPROBLEMS ENCOUNTEREDACTION
Check whether the blowing is coming from inside the luggage compartment from the guard securing the shock absorber to the upper turret.Move on to Step 2.Blowing coming from the fastening of the shock absorber on the upper turret.Fit foam sound insulation above the fastening of the shock absorber to the upper turret.
2BRAKE DISC CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the gap between the brake disc and the steel shield is sufficient.Move on to Step 3Gap too small.Restore the correct gap.
3SHOCK ABSORBER STEM CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Removing the wheel

Op. 4450B12 FRONT WHEELS (TWO) - R+R

Check that the noise is not due to irregular friction between the shock absorber stem and the gasket, checking the condition of the stem chrome surface.

End of diagnosisThere is irregular friction.

Lubricate the stem raising the dust cover, using a layer of silicon grease.

If the noise persists, replace the shock absorber

Op. 4410A12 FRONT SUSPENSION DAMPER (ONE), LH OR RH - FOR MCPHERSON STRUT SYSTEM - INCLUDES DISMANTLING/REASSEMBLY OF ASSEMBLY AT BENCH - R.R

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.