Removing test equipment

Removing test equipment

Remove the test equipment 186955000 with the ignition switched OFF, following the instructions given below:

• place the end of the pipe connected to the valve (c) in a suitable container;
• open the valve (c) and drain the excess fuel into the container;
• keep the pipe in the container and disconnect the end of the supply pipe from the female connector of the adapator (A) keeping the attachment upwards;
• let the fuel in the pipes flow into the container;
• disconnect the end of the adapator (B) from the connector on the fuel manifold and let the remaining fuel flow out of the pipes into the container;
• reconnect the fuel supply pipe to the fuel manifold.

Checking fuel consumption using FLOWTRONIC equipment 1866149001

In order to carry out the check, the equipment should be configured with the connectors shown in the diagrams:
A. supply pipe side
B. fuel manifold side

If this is not the case, carry out the adjustment, proceeding as described below:

• cut the end of the FLOWTRONIC equipment inlet pipe and replace it with a female rapid connector (1) contained in Kit no. 1860955003, as illustrated in figure A;

• cut the end of the FLOWTRONIC equipment outlet pipe and replace it with a male connector (2), contained in Kit no. 1860955003, as illustrated in figure B.

The connectors removed should be recovered and kept for any subsequent connections