Removing test equipment (page 3 of 3)

Before removing the manifold, drain the pressure inside it as described at the beginning of this chapter.

Remove the manifold, proceeding as follows:

• release the front and rear springs (arrow) attaching the cable holder duct to the manifold;
• disconnect the electrical connectors from the injectors and the phase transformer and move the duct released previously aside;
• disconnect the fuel supply pipe (1) from the manifold, working in two stages:

1. press the retaining springs, at the same time pushing the end of the pipe, in the direction shown, to release the housing;
2. keep the springs pressed and extract the end from the manifold;

• undo the two bolts (arrow) fixing the manifold and remove it.

The injectors do not have clips: to remove them, simply release them from their housing (see detail).