Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)09 · 55 Electrical system
09 · Electrical

Alarm

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Alarm › Alarm
55 Electrical systemAlarm

Alarm

Autodiagnosis

When switched on the system carries out an autodiagnosis which can be recognized by the LED flashing at 4 Hz and if there is a problem or fault in the system, the LED will signal it in accordance with the methods described in table 1.

Table 1. Autodiagnosis display

BLINK CODES MEANING
8 Hz, duration 2.5 secs Door/bonnet/boot left open or switch faulty
Light constant, duration 2.5 secs Volumetric sensors faulty

If a fault is detected for the volumetric sensors, then the appropriate sensor is excluded from the surveillance and an audible warning signal (beep) is emitted a second after switching on.

When it is switched off, the system indicates, via the flashing of the LED, which sensor has set off the alarm during the surveillance (see table 2).

Table 2. Signalling cause of alarm

N° of IMPULSES MEANING
1 impulse Right front door
2 impulses Left front door
3 impulses Right rear door
4 impulses Left rear door
5 impulses Additional sensors - volumetric sensors
6 impulses Bonnet
7 impulses Boot
8 impulses +15
9 impulses +30
10 impulses At least 3 causes of alarm
Light constant Transmitter battery discharged

The blink codes are given in order.
These codes have an interval of 1.5 seconds between them.

Manual diagnosis

It is also possible to carry out a MANUAL DIAGNOSIS by opening the lid and turning the ignition key from the ON position to the OFF position; the lid protective button must be pressed within 15 seconds 7 times in rapid succession in less than 10 seconds; 5 beeps will signal the start of the manual diagnosis procedure. After 10 seconds the LED or the direction indicators will flash once.

By entering into this mode the autodiagnostic procedure for the volumetric sensors connected to the control unit will automatically be activated.

If the test does not indicate irregularities, then the direction indicators will flash 3 times and there will be 3 beeps of the alarm.

After this first stage, each time the state of the switches is altered there will be a corresponding quick flash of the direction indicators and a beep, accompanied by the LED in the centre console flashing. If the key is turned to the ON position, the alarm will sound briefly (500 msecs) and the direction indicators will flash (2.5 secs).

This last operation indicates the exit from manual diagnosis procedure. It is also possible to leave the MANUAL DIAGNOSIS by not carrying out any actions for 30 seconds: the exit is signalled by the direction indicators coming on for around 2.5 secs and a beep.

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.