Programming further remote controls using the simplified procedure

PROGRAMMING FURTHER REMOTE CONTROLS USING THE SIMPLIFIED PROCEDURE

In order to programme further remote controls, repeat the procedure for the simplified programming. It is possible to programme an unlimited number of remote controls, but the courtesy light will only keep the last eight in its memory.

This procedure is valid until the following conditions occur:

1. a) the central locking/alarm system has been switched on/switched off correctly via the remote control 256 times;
2. b) the password for one of the remote controls already programmed has been enterе (see paragraph on MANUAL ACCESS PROGRAMMING).

The simplified programming procedure definitively cancels the universal codes present in the courtesy light and alarm control unit.

Protected programming-manual closing of the memory

In order to prevent strangers from being able to enter their code it is necessary to protect (close) the memory. This operation takes place:

1. a) automatically after the alarm system has been switched on/switched off 256 times;
2. b) if the user so desires by entering the password (4 figure code on the transmitter card) before the alarm has been switched on/off 256 times, for example on a new vehicle after all the remote control codes given to the Customer have been introduced.

Entering the password

• The method for entering the password (see lower inset) is as follows:

1. Press the button on the receiver for around 2 seconds: the LED should flash.

2. Release the button: after around 2 seconds the LED should flash briefly indicating that it is possible to enter the first figure of the password.