Programming a new remote control

Programming a new remote control

Alarm

11. Still keeping the receiver button pressed, the operator should hold the new remote control about 40 cm away; then they should press and release the remote control button.
The LED in the courtesy light should come on constantly signalling that the code has been programmed.

12. Release the button: the LED in the courtesy light should GO OFF.

x 6 = OK

At the end of the procedure if the LED:
- FLASHES 6 times then the code has been correctly programmed;
- FLASHES 18 times, then this means that the serial line between the receiver and the alarm is broken.

x 18 = NOT OK

! After having entered the new remote control code the memory becomes closed again automatically. In order to enter a new remote control repeat the procedure from point 1.