Start of simplified programming (first remote control)

The programming of a transmitter should be carried out with the:

1. the emergency key is in the ON position;
2. the anti-theft device is switched off via the remote control;
3. the igntion key is in the OFF position or has been removed.

LED off

LED flashing

LED on constantly

Start of simplified programming (first remote control)

The simplified programming can only be used when the memory has not yet been closed (see chapter on "Protected programming"). The system "recognizes" the code for an unlimited number of remote controls, but only the last eight remote controls remain programmed (when the 9th remote control is entered the first one is expelled from the memory).

1) Press the programming button on the receiver; the LED for the receiver will start to FLASH indicating "awaiting to receive a code";

If the LED remains off when the button is pressed, this means that:
a) the alarm is ON. If this is the case, it can only be switched off using the UNIVERSAL REMOTE CONTROL;
b) the receiver is faulty or there is no supply.