Programming the alarm

Programming the alarm

Alarm

2) - Keep the receiver button pressed;

• hold the remote control about 40 cm away;
• press and release the remote control button;
• the LED in the courtesy light comes on constantly signalling that the code has been programmed.

3) When the button for the receiver is released the LED in the courtesy light goes out. At this point there are two possibilities:

a) To programme the alarm to operate in the country where it will be working (country code).

b) Not to modify the previously programmed operation.

To maintain the default operating mode (ITALY)

In order to programme the alarm following the instructions in point "a" it is necessary to press the programming button, within three seconds of the LED going out, as many times as indicated in the table at the side.

[!] Each time it is pressed the LED will flash.